More Center Spar Drilling

About 2 more hours spent on the center spar.  Placing and drilling another vertical angle.  Getting a bit better.   Only measured and cross checked five times before committing to the drill.  I have found that drilling up from 1/8" works best.  Here is the work done this evening.

Also spent some time cleaning my work table.  It was getting quite cluttered and messy and I was having a hard time locating tools and parts as I worked.  A congested work area is not conducive to efficient and accurate work I have found.

Tomorrow I will drill the rivet holes - if my rivet spacing tool gets delivered on time :)

Thanks for checking in.

Greg -